Truk jungkit

Fliegl DHKA 390 30 m³

Customized transport solution
Configure according to your requirements. The vehicle shown is an example. Production and equipment are customized according to customer requirements.

Further information
Chassis
Fine-grained steel welded construction, lightweight design, kingpin plate with 2 interchangeable kingpins
Curved front end, patented
Telescopic support in the center, cannot be uncoupled while loaded, when uncoupled, the vehicle must be tilted backwards.
2 support wedges with holder
Underrun protection, foldable
Half-shell fenders
Integrated fender holder, surface designed to deflect stones
With anti-spray flaps, only on the last axle
1 tarpaulin rod with holder
2 towing hooks at the rear
Axles + Suspension
SAF disc brake axles with 430 mm disc diameter
Axle/chassis laser-measured to reduce tire wear and fuel consumption
Axles in off-road design
Air suspension
1st axle: automatic lift axle, including forced lowering & start assist, activated 3 times by the brakes (start assist functional up to an axle load exceeding 30% and a speed of max. 25 km/h)
Hot-dip galvanized lift axle mechanism, 10-year warranty against rust-through
Braking system
2-line compressed air, color-coded lines for easy servicing
Spring-loaded parking brake
2 fail-safe coupling heads at the front, without connecting line
EBS, electronic braking system with EBS socket at the front, without connecting cable
Note: The trailer may only be towed by towing vehicles that guarantee the effectiveness of ABS!
With lifting and lowering valve
Vehicle stability system
Automatic tilting lowering + shut-off valve
Wheels + Tires
385/65R22.5, manufacturer's choice
Steel rims, factory silver
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red marker lights at the rear
2 x 7-pole fail-safe sockets at the front, without connecting cable
Hydraulics
Low-pressure cylinder max. 170 bar, smallest stage hard-chromed, with HDK screw collar, fixed part, NW 48 mm.
Actuation hydraulically via truck auxiliary drive
Tippers
Aluminum box tipper made of high-quality, abrasion-resistant material, front panel 5 mm thick, with external side panels made of 30 mm hollow section profiles, cleanly welded, with upper profile designed to prevent spillage. Inside with access ladder on the front panel.
Shovel and broom holder on the outside of the front panel.
Greenline - conical and aerodynamic tipper body design
Lrodpfxji Ri H Ij Apton
Membrane - rear wall
Rear wall as a swing gate with double-hinge hinge, mounted externally with a double hook lock.
Rear wall with rubber seal. Note! Heat-resistant up to max. 170°C!
Floor continuously 6 mm thick
Standing platform with access ladder, connection plate for air/electricity and brake with plenty of space for the best possible operation.
Roller cover on one side for stowing on the right, with central locking on the left
Operating instructions
For transporting salt, lime, etc., we recommend a tipping cylinder with a hard-chromed piston rod to protect against rust.
The stated total weight is technically possible; depending on the load, the total weight may not be reached while observing the permissible axle/support and kingpin loads. (Poor driving and tracking behavior possible due to incorrect load distribution)
Country of registration / Signs
Germany
Type approval according to EC 2007/46
24/7 service hotline
Prepared for single-line license plate holder
Contour marking with reflective tape according to ECE

Iklan ini diterjemahkan secara otomatis. Kesalahan terjemahan mungkin terjadi.