Sistem peleburan laser

Renishaw RenAM 500 S-FLEX

Processable materials: Metals in powder form, including stainless steels, tool steels, aluminum alloys, nickel-based alloys, and titanium alloys.
For further information on materials and surface quality, please refer to our website.
Net weight: 1,870 kg
Laser type: Ytterbium fiber
Laser power: 1 × 500 W
Fpodpfsv Ewpnex Adqon
Dimensions: 2,165 mm × 1,236 mm × 2,130 mm (L × W × H)
Build volume (1): 250 mm × 250 mm × 350 mm (L × W × H)
Powder layer thickness: 20 μm to 120 μm
Typical process speed (3): 2 m/s (max. 10 m/s)
Build rate (2): Up to 254 cm³/h
Laser spot diameter: 80 μm with dynamic focus
Dynamic focus diameter: Up to 500 μm
Laser wavelength: 1,070 nm to 1,080 nm
Maximum laser modulation frequency: 20 kHz
Build chamber atmosphere preparation time: 15 minutes (to < 1,000 ppm O₂ concentration)
Consumption during system filling/emptying: < 1,200 l
Maximum argon consumption (during filling): 400 l/min
Continuous argon consumption (after initial filling): < 0.8 l/min
Chamber working pressure: 10 mbar to 20 mbar
Argon gas supply connection: 3/8 in BSP plug-in connector
Argon quality: Maximum 20 ppm permitted impurity or better (purity level 99.998%)
Power supply (4): 380 V to 480 V AC, 63 A, 50 Hz to 60 Hz, 3-phase
Data connections (5): Standard RJ45 network port. Renishaw recommends Cat 6 grade power cables.
Ideal operating temperature (7): 18°C to 22°C (min./max.: 15°C to 28°C)
Ideal relative humidity (7): < 60% (max. < 80%)
Clear height under the machine (without plinth): 146 mm
Optical module protection rating: IP5X
Noise level: ≤ 70 dB
Compatible software: QuantAM, InfiniAM Camera, InfiniAM Spectral, Renishaw Central, and selected third-party software
(1) 'Build volume' refers to the maximum internal chamber space, typically the usable area is smaller. The substrate plate is not included in these dimensions.
(2) The maximum build rate does not include recoating time and depends on settings, component geometry, and material.
(3) Typical process speed depends on settings, component geometry, and material.
(4) The calculated maximum machine load is 50 A, rated operating current is 32 A.
(5) Users can configure the network using their own control software. For details, refer to the operating manual, RenAM 500 Series Additive Manufacturing System, Renishaw Part No. H-5800-3693.
(6) Due to varying electrical requirements in different countries, part numbers for accessories may differ. Please contact your local customer service for details.
(7) Temperature and humidity should not both reach their respective maximum values at the same time and must remain below the dew point of 16°C (61°F) to avoid condensation on laser components. See site preparation and installation instructions for the RenAM 500 Series Additive Manufacturing System, Renishaw Part No. H-5800-3692.

Iklan ini diterjemahkan secara otomatis. Kesalahan terjemahan mungkin terjadi.