Mesin pembentuk pipa, pengolahan ujung pipa

transfluid Maschinenbau GmbH REB 632

Tube end forming machine, axial tube processing, tube end sizing machine, tube swaging machine, swaging machine for tubes, tube end processing, axial tube deformation, tube forming machine, expanding, reducing, expanding machine, reducing machine, beading, flaring, tube forming

Performance:
- Suitable for round tubes from 6–32 mm Ø (depending on forming geometry)
- Maximum wall thickness 1.5 mm for tube Ø 32 mm in ST 37
- Forming force 98 kN
- Clamping force 98 kN
- Forming length 80 mm
- Number of forming stages 3
- Cycle time (1st stage) 3.5 sec.
- Cycle time (per additional stage) 2.5 sec.

Machine equipment / Basic configuration:
- For axial forming of tube ends, e.g., reducing, expanding and beading forming
- With automatic tool changer for up to three forming stages in a single clamping
- Tool change via servo motor
- Electrohydraulic drive
- Includes position measuring system for the forming axis for easy programming and cycle time optimisation, minimising wear and noise
- Clamping length depends on tube size, approx. 150 mm
- Forming process is dependent on the specific tooling
- Forming length is limited by the tool geometry
- Hydraulic tube clamping
- Hydraulic tube forming
- Clamping cylinder Ø 80 mm
- Forming cylinder Ø 80 mm
Nedpfxewvq Sve Agiedd
- Includes connections for pneumatic jaw shifting tools
- Standard hydraulic and control components
- Machine mounted on a sheet metal base frame (with integrated hydraulics and electrics)

Machine data:
- Rated pressure 250 bar, working pressure 160 bar
- Operating voltage 400 Volt – 50 Hz – 3 ph. – 9 kW
Average power consumption of the machine is approx. 3.6 kWh/h. Actual consumption strongly depends on factors such as tube size and geometry, speed, and power supply, so this value is a guide only.

- Length 1,950 mm
- Width 1,600 mm
- Height 2,000 mm
- Weight approx. 1,900 kg

Iklan ini diterjemahkan secara otomatis. Kesalahan terjemahan mungkin terjadi.