Mesin die casting ruang panas - Vertikal

FRECH DAW 80S

Clamping force: 900 kN
Clamping plate: 540 x 540 mm
Tie bar distance: 350 x 350 mm
Machine weight: approx. 5.5 t
Clamping stroke: 280 mm
Ejector force: 60 kN
Ejector stroke: 70 mm
Mould height: 160–400 mm
Tie bar diameter: 65 mm
Injection force: 75 kN
Injection stroke: 130 mm
Injection plunger diameter: 50, 55, 60 mm
Casting volume (DIN 24480): 119, 163, 214 cm³
Specific injection pressure: 380, 315, 265 kp/cm²
Corresponding parting surface: 236, 285, 340 cm²
Core pull stroke: 150 mm

Completely overhauled die casting machine DAW 80 GO with DataLogic control for processing zinc alloys.

Partial extract of the general overhaul:
• Upgrade of the machine with a new control cabinet and new operator panel, including replacement of all electrical wiring
Dcodpfxjyzt D Eo Ahuef
• Renewal of hydraulics (blocks and valves)
• Overhaul of the clamping unit
(Detailed list available on request)

The machine is equipped with the following options:
• Motorised safety door, injection side left
• Discharge chute cover on base frame (straight)
• Standing operator panel
• Discharge chute cover on base frame
• Multi-chamber holding and melting furnace with TOC pump
• Furnace control cabinet for furnace type Z
• Use of water-glycol
• Side GO
• Wired signal interface for part removal (DISPO10)
• RSD equipment package with switch
• Spraymotion 611 E with servo drive, single-circuit
• Release agent container TD 20
• Spray bar CR 275

Additional options are available on request.

Iklan ini diterjemahkan secara otomatis. Kesalahan terjemahan mungkin terjadi.