Mesin hobbing gigi - horizontal

MIKRON A 33/1

Wheel diameter – max. 80 mm
Wheel width 150 mm
Module – max. 2.5
Module – min.
Total power requirement 10 kW
Machine weight approx. 2400 kg
Fully automatic hobbing machines for worm gears
Type A 33 / 1 Year of manufacture 1985 Serial No. 14.06/14.07/14.15
TECHNICAL DATA:
Max. gear diameter without loading magazine approx. 80 mm
Max. gear diameter with loading magazine approx. 50 mm
Module max. 2 / 2.5
Axial milling length approx. 150 mm
Max. workpiece installation length approx. 200 mm

Milling slide swivels up to 90 degrees
Cutter diameter 24 – 50/63 mm
Max. radial travel of milling slide 0–14/18 mm
Max. cutter shift 25 mm
Cutter speeds 212 – 2,000 rpm
Axial feed range, stepless 0.05 – 4.0 mm/rev
Radial feed range, stepless 0.2 – 200 mm/min

Milling spindle drive 3 kW
Total drive approx. 10 kW – 50 Hz – 380 Volt
Weight approx. 2,400 kg

Accessories / Special equipment:
Fully automatic workflow and minimal idle times thanks to freely programmable SIEMENS S5 PLC control for all processing steps such as rapid traverse, feed, cutter on/off, for the loading device, tailstock, optional shifting, etc., and with part counter, program numbering, and 30-stage numerical fault display.
Pneumatic workpiece loading and unloading device aligned parallel to the workpiece axis for shaft-type parts approx. 140 mm long x 8 mm diameter, with pneumatic double gripper for feeding and removing workpieces; blanks are loaded externally in exchange cassettes and inserted into the loading unit.
The double gripper places the parts between workpiece spindle and tailstock, the tailstock quill pushes the parts into the main spindle collet, clamping them simultaneously.
Finished parts are ejected from the main spindle and returned by the gripper to the (finished parts) cassette. The entire process is electronically monitored and controlled.
The entire loading device is enclosed in Plexiglas.
Hydraulic workpiece clamping device with collets and hydraulic ejector
Separate coolant system with magnetic separator * separate hydraulic unit * various change gears
Condition: good – 3 machines available, currently 1 machine ready for demonstration (powered),
Machine is set up for hobbing worm shafts/armature shafts used in variable transmission drives for vehicle seats, window winders, etc.
Lhedpfx Aet Hw D Rokzjl

Iklan ini diterjemahkan secara otomatis. Kesalahan terjemahan mungkin terjadi.