Edgebander

IMA NOVIMAT / CONTOUR / I / G80 / 790 / L20

Single-sided IMA NOVIMAT / CONTOUR / I / G80 / 790 / L20 edge banding machine with MFA servo corner copying unit
Year of manufacture: 2009
Technical condition: very good

- Sturdy machine frame with mounting points for individual processing units.
- Feed speed drive, electronically regulated from 6–30 m/min
(processing units’ operation speed is not synchronized with the full feed speed adjustment range).
- Feed chain guided in slide rails with plastic inserts
and an 80 mm wide rubber lining.
- Automatic feed chain lubrication, controlled via the machine’s program.
- Upper pressure assembly with dual V-belt (70 mm wide), running on roller bearings;
electrically adjustable pressure position.
- Machine safety according to CE certification.
- Noise reduction and safety covers.
- Edgebanding unit with drive contained in a tightly sealed oil bath with glue pot
(1 main driven pressure roller + 5 auxiliary rollers); pneumatic Quick-Lock glue pot
fast-change system for rapid replacement.
- Touch-screen control panel.
- End trimming saw unit for trimming edge overhang on the front and rear corners
with functions: pneumatic saw adjustment in the range 0–25°, straight cutting and corner chamfering,
automatic setting of chamfering saws for two different edge thicknesses (e.g. 0.4 & 1.2 mm)
and setting edge overhang for corner copying.
- All processing units fitted with chip extraction connections.
- Novimat Contour series edgebanders offer high-quality finishing due to powerful corner copying unit
and minimal gap between elements (~300 mm).

Main technical data:
- Edge from roll thickness: 0.3–3 mm
- Paper, PVC, and ABS edge: 0.3–3.0 mm
- Veneer: 0.5–3.0 mm
- Solid wood strips: 0.8–20 mm
- Edge height: 14–65 mm
- Maximum edge overhang (top):
• up to 8 mm edge thickness – 5 mm
• above 8 mm – 2 mm

Workpiece dimensions:
- Minimum element length (feed direction): 150 mm
- Minimum element width (for pieces up to 25 mm thick): 65 mm
- Minimum element thickness: 8 mm (without flat scraper) or 12 mm (with flat scraper)
Chsdpow R S Slefx Adpoc
- Maximum element thickness:
• without corner copying: max 60 mm
• with corner copying: max 40 mm
- Smallest element: 150 × 150 mm or 65 × 300 mm
(note: * 65 mm for maximum element thickness of 25 mm)

Machine technical parameters:
- Electronically regulated feed speed: 6–30 m/min
(note: feed speed may be limited by individual machine units)
- Workpiece overhang beyond feed chain:
• 38 mm (including edge thickness 0.3–8 mm)
• 30 mm (including edge thickness 8.1–20 mm)

Power supply:
- Voltage: 400/230 V, +5/–10 % with neutral
- Frequency: 50 Hz
- Control voltage: 230 V AC / 24 V
- Compressed air: 8 bar
- Extraction air speed: 28 m/s

Iklan ini diterjemahkan secara otomatis. Kesalahan terjemahan mungkin terjadi.