Sander sabuk lebar

SCM DMC SD 60 - RCS 110

- NEW -

GENERAL FEATURES:

Machine Frame and Work Table
* Steel construction with electrical control cabinet at the front of the machine
* In-feed of sanding belts from the left side of the machine
* Motorized table height adjustment
* Main motor integrated within the machine frame

Electrical Equipment
* Electromechanical control panel on the front left side of the machine
* Automatic star-delta starter for main motor
* Motor protection switches for all motors
* Motors with IP54 insulation class

Emergency and Safety Devices
* Safety micro-switch for thickness overrun
* Automatic brake for instant stop of the units
* Emergency stop bar at workpiece infeed
* Mushroom (palm) switches at the workpiece infeed and outfeed
* Lockable main switch
* Automatic emergency shut-off of the machine in the event of:
- Sanding belt breakage
- Un-tensioned sanding belt
- Lateral deviation protection for the sanding belt
- Insufficient air pressure
- Main motor overload

Note: The standard version with 400 Volt 50 Hz requires a three-phase power supply + neutral + earth. If the 400 Volt power supply does not have a neutral, a single-phase transformer (see price list) must be ordered. The same transformer is required for machines with voltages higher than 400 Volt, regardless of the presence of a neutral. A version for 220 or 230 Volt (50 or 60 Hz) is available at extra cost (see price list).

Kedpfx Aaovwfrnohenf
BASIC MACHINE STANDARD EQUIPMENT
- R140/85 rubber-coated calibration roller, diameter 140 mm, 85 Shore - 1st position
- R160/45 rubber-coated sanding roller, diameter 160 mm, 45 Shore - 2nd position
- Hard sanding pad with manual working height adjustment
- Main motor 11 kW (15 HP)
- Electronic ammeter for main motor to display power consumption
- Electronic readout of working height
- Electronically controlled sanding belt oscillation
- Rubber pressure rollers
- Anti-kickback device at infeed before the first unit
- Rubber feed belt, 60 Shore
- Roller table with two rollers at the infeed and outfeed of the work table
- Feed belt with two speeds 4.5 / 9 m/min with geared motor
- Automatic belt centering

Working width mm 1,100
Min./Max. working height mm 4 - 170
Sanding belt width mm 1,115
Sanding belt length mm 2,150
Main motor power kW (HP) 11 (15)
Geared motor kW (HP) 0.45/0.8 (0.6/1.1)
Feed speed m/min 4.5/9

Consisting of:

10.90.87 European safety directives (CE marking)
93.07.31 Voltage 400 EU
93.12.01 Frequency 50 Hz
44.44.19 Version "B" for RCS
33.31.50 Roller table at infeed and outfeed for long workpieces
62.44.50 10" control panel with “eye-S” software integration
31.21.60 "RA" grooved steel contact roller – 1st unit
97.50.71 Main motor 15 kW (20 HP)

Iklan ini diterjemahkan secara otomatis. Kesalahan terjemahan mungkin terjadi.