HBC 110 K / 75 kW

Bollegraaf Recycling Solutions B.V. HBC 100 K

For sale is a refurbished baler with 100 t press force, large-format bales 1100 x 1100 mm, 75 kW drive power and 10-way cross-tying.

Technical specifications baler:
Manufacturer: Bollegraaf
Model: HBC 110 K / 75 kW
Year of manufacture: 2007
Main press force: 100 t
Pre-press force: 50 t
Operating hours: 22,605 h
Feed opening dimensions: 1,600 x 1,100 mm
Filling volume / press cycle: 3.15 m³
Theoretical cycle time: 19 seconds
Bale size: 1,100 x 1,100 mm
Drive power: 75 kW
Connected load: 126 kW
Total current consumption: 238 A
Tying: 5-fold vertical, 5-fold horizontal, fully automatic
Throughput at bulk density of:
- 30 kg/m³: approx. 16 t/h
- 50 kg/m³: approx. 25 t/h
- 100 kg/m³: approx. 47 t/h
Bale weight up to 1,400 kg, depending on material and bale length
Hydraulic oil tank capacity: approx. 1,300 l
PLC control: Telemecanique TSX Micro
Operating panel: Schneider MAGELIS Touch
Baler dimensions with hopper: 11,750 x 5,000 x 7,105 mm (L x W x H)
Transport dimensions without baler: 11,765 x 2,500 x 3,450 mm (L x W x H)
Baler weight: approx. 36 t

Remarks:
The baler has been partially overhauled, serviced in our workshop, and tested after completion of work before being stored. The machine is available at short notice and can be inspected at our warehouse by appointment.

The following refurbishment works have been carried out:
- Descaling and partial repainting of the baler.
- Hydraulic oil tank drained, oil and air filters replaced.
- New hydraulic oil filled.
- All hydraulic hoses renewed.
- Main hydraulic cylinder, two cylinders of the pre-press flap and the channel cylinder disassembled, dismantled, inspected, cylinder tubes honed, all seal kits replaced and final pressure tested.
- Pre-press flap with bearings and bearing blocks disassembled. First and third circular arc segments removed and newly welded in.
- Both shaft bearings for the pre-press flap renewed.
- Upper material guide on the frame for the pre-press flap renewed.
- Plunger disassembled, inspected and both front roller guides renewed.
- Material guides and wear strips at the sides and on the bottom of the plunger cut out and newly welded in.
- Horizontal and vertical needle and tying units disassembled, dismantled, inspected, plastic slide plates, bearings on twister shafts, and wire divert rollers with bearings in the needle heads renewed.
- Both bronze slide rails left and right in the frame cover for the plunger renewed.
- Both wire divert units left and right, including bale retaining clamps, fully renewed.
- Wire infeed unit including hydraulic cylinder below the needle passes fully renewed.
Rjdjvf E Avjpfx Amusu
- Wire mark/scoring in the bottom and sidewalls of the channel welded up and smoothed.
- General maintenance and service work carried out in line with manufacturer specifications.
- Baler tested in manual and automatic mode, accepted and stored after completion of refurbishment works.

We assume no liability for the technical details or possible errors.

Iklan ini diterjemahkan secara otomatis. Kesalahan terjemahan mungkin terjadi.