Ballenpresse 50 t, Antrieb 22 Kw mit Wirbulator

Presona LP 50 EH1

Technical Data – Baler:

Manufacturer: Presona AB
Model: LP 50 EH1
Year of manufacture: 2005
Operating hours: 30,408 hours (as of April)
Number of bales produced: 198,059 pieces (as of April)
Main press force: 50 t
Specific pressure: 63 N/cm²
Theoretical throughput: 530 m³/hour
Throughput under operating conditions: 260 m³/hour
Hodpfx Asy R Npisansfg
Feed hopper dimensions: 1,250 x 1,100 mm
Press chamber volume: 2.2 m³
Bale dimensions: 1,100 x 720 mm, variable length
Drive power: 22 kW
Tying: 5-fold vertical, fully automatic
Throughput rates at bulk density of:
- 30 kg/m³: 6 to 7 t/hour
- 50 kg/m³: 7 to 9 t/hour
- 100 kg/m³: 11 to 14 t/hour
Bale density (paper/newspapers): 400 to 550 kg/m³
Hydraulic oil tank capacity: 600 l
PLC control: Telemecanique TSX Micro
Control panel: Schneider Magelis
Transport dimensions (excluding baler): 8,125 x 2,300 x 3,000 mm (L x W x H)
Transport weight (baler): approx. 16 t

Condition of the Baler:
The machine has been partly overhauled in our workshop and general maintenance work has been carried out. Upon completion of the refurbishment, the baler was tested during operation and is now ready for immediate sale.

The following refurbishment work has been carried out:

General work:
- Machine cleaned, derusted, primed, partially repainted
- Wire feed marks in the feed channel welded and smoothed

Hydraulic unit:
- Hydraulic oil tank drained, tank cleaned, refilled with new oil
- Oil filter and air filter replaced
- Leaking oil sight glass on hydraulic oil tank replaced
- All hydraulic hoses replaced

Electrics:
- Program menu language set to English
- Two key switches in the control panel replaced
- Control cabinet replaced
- Signal lamp on the control cabinet replaced
- Flap limit switch replaced
- Electrical system of the agitator replaced, connected, and tested

Press ram:
- All four rollers on the press ram removed and replaced
- Main hydraulic cylinder disassembled, overhauled, cylinder tube honed, all seals replaced, leak test conducted
- All plastic wear blocks on the press ram replaced

Pre-press flap:
- Both bearings on the shaft of the pre-press replaced
- Both hydraulic cylinders disassembled, overhauled, both cylinder tubes honed, all seal kits replaced, leak test conducted
- Scraper flap on the pre-press replaced

Tying system:
- Two complete needles with wire redirect rollers replaced
- Needles adjusted and set
- All wire redirect rollers in the needle heads replaced
- Twister finger replaced
- Two twister shafts replaced
- All 8 wear plates on the twister, under the twister fingers, replaced

Scope of delivery:
Only the baler is being sold.

All documentation (operating manual, CE declaration, electrical/hydraulic circuit diagrams) is fully available. Inspection possible by appointment. We do not accept liability for the technical information and possible errors.

Iklan ini diterjemahkan secara otomatis. Kesalahan terjemahan mungkin terjadi.